/**
 * \file TrigLevel2.h
 * \author Gianfranca DeRosa / Wolfgang Menn
 */


#ifndef TrigLevel2_h
#define TrigLevel2_h
//
#include <TObject.h>
#include <TClonesArray.h>

#include <TrigStruct.h>

/**
 * \brief  Class which contains the Trigger data
 *
 */

class TrigLevel2 : public TObject {
 private:

 public:

  UInt_t         evcount; ///<event number starts from 0 at each new run
  UInt_t         pmtpl[3]; ///<Rate counters top / middle /bottom
  UInt_t         trigrate[6]; ///<Rate counters of trigger configurations TOF 1/2/.../6 (time base 4 seconds)
  UInt_t         dltime[2];  ///<livetime  or deadtime live=0.16*dltime[0]; dead=0.01*dltime[1]
  UInt_t         s4calcount[2]; ///<Rate counters of s4 and calorimeter (time base 4 seconds)
  UInt_t         pmtcount1[24]; ///<Rate counters of the first 24 pmt's (S111a,...,S118a,S111b,...,S118b etc. look at the QL sequence)
  UInt_t         pmtcount2[24]; ///<Rate counters of the last 24 pmt's
  UInt_t         patternbusy[3]; ///<Too complex to describe, basically there are 3 registers which store the status of the busy lines of all the detector in the 3 phases of acq. (after the trigger, when IDAQ set the busy and when iDAQ remove it)
  UInt_t         patterntrig[6]; ///<What is used in the trigger. One has to do some bit shifting to check the values
  UInt_t         trigconf; ///<Gives the trigger configuration by bit shifting. For example: "trigconf & (1<<0)" => TOF1
  Int_t          unpackError; ///<is a flag set in case of CRC errors during the unpacking of data
  //
  // here you can define methods to make life simplier during the analysis
  //

  //
  // constructor
  //
  TrigLevel2();
  //
  // 16 June 06: Included GetTrigLevel2
  TrigLevel2*   GetTrigLevel2(){return this;};
  void SetFromLevel2Struct(cTrigLevel2 *l2);
  void GetLevel2Struct(cTrigLevel2 *l2) const;


  void Clear(); //emiliano
  
  ClassDef(TrigLevel2,2);
};

#endif